← All videos Fans & air side

Does the Pool Dehumidifier Keep Up with Evaporation?

Same pool, same unit, three evaporation methods. HVACinOne shows the dehumidification margin or shortfall in one result table.

0:48

A pool dehumidifier is only proven when it is checked against the pool's own evaporation load. In practice the two numbers come from different places. The unit's kg/h comes from a datasheet, and the pool load comes from a separate spreadsheet. On top of that, the method you pick for the pool load changes the answer.

HVACinOne puts both sides in one calculation. One unit covers five operating modes. The equipment stays the same, only the air path changes, and the compressor runs in two of the modes. The pool load is calculated from the pool itself: pool type, water surface, water temperature, swimmers and hall conditions. You can use VDI 2089-1, ASHRAE or Shah, or compare all three. What the unit removes comes from the hall humidity balance, not from vendor condensate figures. Removed and evaporated moisture sit side by side in the same result table.

Take the recirculation dehumidifying mode at 4500 m³/h. The hall is at 27 °C / 50 %. Hall air holds 11.20 g/kg and the supply air leaves at 9.30 g/kg, so the unit removes 10.24 kg/h. The pool is a hotel pool with 40 m² water surface, 28 °C water and 6 swimmers. ASHRAE gives 9.25 kg/h evaporation, a margin of +0.99 kg/h. Shah gives 11.92 kg/h, a shortfall of −1.68 kg/h. VDI 2089-1 gives 12.15 kg/h, so the unit is 1.91 kg/h short. In this example the unit passes only by ASHRAE.

This helps engineers who design pool halls. They see a shortfall at selection, not after the hall is in use.

Want to see this with your own products?

We set up HVACinOne with your unit data and show the same calculation on your range.

More videos